baker drivetrain
Disponibilité : En stock
Information :
- Poulies en acier inoxydable
- Une pièce d'embrayage en acier panier
- 2.4 "bande large exclusive
- Support usiné en aluminium billet et les couvertures de poulie
- Disponible en configuration 0 "ou 1/2" de déport
– 28 tooth stainless steel pulley up front and a 43T stainless steel pulley in the rear
– 1.58 pulley ratio yields a 7% increase in torque to the rear wheel
– One piece 66 tooth 1045 steel ring gear
– 2.4″ Wide proprietary belt with 14mm teeth
– 12 plate clutch pack holds up to 120 ft-lbs of continuous use while the tight tolerance clutch baskets all but eliminates the ‘neutral clutch rattle ‘ most belt drives suffer from
– Billet 6061-T6 aluminum outboard support and pulley covers
– Motor plate and edge guard are machined from 6061-T6 billet plate stock
– Comes standard with outboard support and a show polished finish.
– Available as a 0″ or 1/2″ offset configuration
As shown below left, is a used aftermarket clutch basket, made from Aluminum. As you can see, after time, virbation of the clutch pack inside the basket wears grooves in the flanks of teeth. Anyone who has wrenched for at least one riding season, has seen this phenomenon in the flesh. These wear marks when they start, cause clutch disengagement issues, shifting issues and trouble finding neutral. When they get to be as bad as this picture, you have to replace the entire basket at your expense. The wearing of the clutch plates into the basket, and the belt into the pulleys is why we designed our belt drive with 1045 steel pulleys. The same material we used on our secondary drive pulleys. Also pictured is a common aftermarket belt (on the bottom) with 8mm teeth, our 14mm tooth belt is just above it. The larger tooth size has more meat to it, and thus can hold more force per tooth. If a 14mm tooth belt size can drive the supercharger on a 500ci Top Alcohol Dragster motor, your bad ass Big Dog will be just fine.
Disponibilité | Supprimé du catalogue |
---|---|
Marque | Fondée en 1998 par un passionné et ancien génie mécanique de chez General Motors, l'entreprise Baker Drivetrain s'efforce de créer les meilleurs embrayages, roulements, poulies de transmission et autres pièces détachées destinées à la réparation et la customisation de votre deux-roues. |