Chain Driven Cam

Allow you to upgrade your 99-06 Twin Cam (except 06 Dyna Glide) to the newer roller-style cam chains and replaces the spring tension cam chain adjusters with the later-style hydraulic adjusters for longer life

Cam grinds listed are designed to be used with stock lifters; they require the installation of a 07-17 cam plate, oil pump, cam sprockets and chains, and both hydraulic chain adjusters (these parts are not included and must be purchased separately)

A list of required components is supplied with each set of cams

Performance should be similar to earlier bikes with the same cam grinds

Made in the U.S.A.

99-06 Twin Cam motors (except 06 Dyna Glide) cannot use the 07-17 cams, as the bearing journal on the earlier motors is .875" in diameter and the 07-17 cams are 1.000" in diameter. The "N" series of cams feature the .875" bearing journal, yet still accept the new style cam support plate

99-01 model motors must use the Andrews rear cam sprocket Drag part #0925-0147. 2002-2006 models must use the stock rear cam sprocket, OEM #25728-06

Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance

Designed for easy installation in 95 inch motors with stock headsFor lighter bikes with 9.5:1 to 9.8:1 compression ratio (2400-6000+ RPM)Can be used with stock valve springs and tappets, but valve travel must be checked (minimum .620")Piston-to-valve and valve-to-valve clearance must be checked